canoscan 9000f mark ii software not working

ID 04a9:190d whereas the udev/rules.d/55 libsane file gives If I look at file /etc/udev/rules.d/55 libsane rules it has two lines Canon CanoScan 9000FĪTTR=“yes” When I open a console and type lsusb I getīus 001 Device 005: ID 04a9:190d Canon, Inc. When I select Hardware info in YaST I get (relevant bit) If I select this the response is pixma driver no scanner recognised. If I then select Add Scanner there is a lineĬanon CanoScan 9000F : (Package sane-backends) Driver pixma should provide complete functionality (USB-ID 0x04a9:0x1908) When I connect it and use YaST - hardware - scanner it says no scanner recognized. The prints from my negatives look fine.I have bought one since the Suse Hardware list says that it is fully supported.

I have tried various different settings in the Canon Scangear software as well as turning everything off, nothing seems to help. I am wondering if the scanner is defective, or if this what I should expect for a sub $200 scanner? Would I see better results from the Epson? I have gotten some good frames from the Canon software, but overall the results are so varied, that it will not work for me when it comes time to archive my entire negative collection, as I’m not willing to process thousands of individual images. (These are the only two types of film I have tried so far.) I downloaded VueScan and the results are better, but I still notice the problem.

I seem to get severe blotchiness on my Kodak Ektar 100 film scans, and severe digital noise on older Fuji 400 scans. Unfortunately, I am disappointed with the results I am getting.

I did a lot of comparing between the Epson v600 and Canon and didn’t see much of a difference, so I decided to buy the Canon since it was on sale. Hi, I recently purchased a Canon 9000F Mark II primarily to archive my old 35mm negatives and also to scan film that I am currently shooting.

Canoscan 9000f mark ii software not working